Re: [Handle-info] information flow of the traffic for port 2641

[Robert Tupelo-Schneck <schneck@cnri.reston.va.us>]

Hello!  Port 2641 is the port registered for the Handle protocol.  You  
can read about the protocol in RFC 3652 (http://tools.ietf.org/html/rfc3652 
).

Handle protocol messages can be encoded and transmitted over the HTTP  
protocol on port 8000, however this method has significantly higher  
network overhead compared to sending native handle messages over UDP  
on port 2641.  Handle over HTTP on port 8000 is intended only as a  
fallback for clients who have some trouble with port 2641 (e.g. for  
firewall reasons).

Best,
Robert

On Apr 24, 2009, at 2:07 AM, LEYAU Wie Leng (CSC) wrote:

> Hi guys,
>
> Does anybody know what is the information flow of the traffic for  
> port 2641? Understand for port 8000 is a http port (incoming only)  
> to respond to requests related to the handle service, but what about  
> for 2641?
>
> Thanks and Regards,
> Wie
>
> National Institute of Education (Singapore) http://www.nie.edu.sg
>
> DISCLAIMER : The information contained in this email, including any  
> attachments, may contain confidential information. This email is  
> intended only for the use of the addressee(s) listed above.  
> Unauthorised sight, dissemination or any other use of the  
> information contained in this email is strictly prohibited. If you  
> have received this email by fault, please notify the sender and  
> delete it immediately.


_______________________________________________
Handle-Info mailing list
Handle-Info@cnri.reston.va.us
http://www.handle.net/mailman/listinfo/handle-info